在日常使用混凝土攪拌車的時候，車主朋友們是否有留意預拌混凝土操作及供水操作？下面小編就帶大家來了解一番。
When using the concrete mixer daily, do the car owners pay attention to the operation of ready mixed concrete and water supply? Now I'll take you to know something.
一、預拌混凝土正確操作：
1、 Correct operation of ready mixed concrete:
a、先注入總水量2/3的水。
a. First, inject 2/3 of the total water volume.
b、將1/2的粗骨料，1/2的砂，全部的水泥順次送入攪拌筒，隨后再將余下的1/2粗骨料和水送入。
b. 1/2 of the coarse aggregate, 1/2 of the sand and all the cement are sent into the mixing drum in sequence, and then the remaining 1/2 of the coarse aggregate and water are sent into the mixing drum.
c、攪拌筒轉速及攪拌時間“進料時攪拌筒的轉速：6—10轉/分；攪拌時攪拌筒的轉速：6—10轉/分；攪拌時間：10—16分鐘。
c. Rotating speed and mixing time of mixing drum: rotating speed of mixing drum during feeding: 6-10 r/min; rotating speed of mixing drum during mixing: 6-10 r/min; mixing time: 10-16 min.
d、攪拌完畢后的攪動及出料方法與前述相同。
d. The stirring and discharging methods after mixing are the same as those mentioned above.
二、供水系統正常操作：
2、 Normal operation of water supply system:
1、采用水泵供水：
1. Water is supplied by water pump:
a、先打開駕駛室里的水泵翹板開關，再打開蜂鳴開關，水泵即可工作，同時，蜂鳴器發出“嘟嘟嘟”的叫聲。
a. First turn on the rocker switch of the water pump in the cab, then turn on the buzzer switch, and the water pump can work. At the same time, the buzzer gives out a "beep beep" sound.
b、向攪拌筒內加水或沖洗料斗槽時，開啟“料斗”閥門。
b. When adding water to the mixing drum or flushing the hopper tank, open the "hopper" valve.
c、沖洗出料溜槽時，開啟溜槽閥們。
c. When flushing the discharge chute, open the chute valves.
d、沖洗車身時，先開啟水槍閥門，而后可直接使用車尾水槍。
d. When washing the body, first open the water gun valve, and then directly use the tail water gun.
2、采用氣壓供水：
2. Pneumatic water supply:
①先打開駕駛室供氣開關，當主車壓力表達到8kg/cm2壓力再打開供水系統手動氣開關，當壓力表達到2kg/cm2壓力時即可工作。
① First turn on the air supply switch in the cab. When the main vehicle pressure reaches 8kg/cm2, turn on the manual air switch of the water supply system. When the pressure reaches 2kg/cm2, it can work.
②向攪拌筒內加水，沖洗料斗槽、卸料槽時，先開啟水箱底部閥門，再開啟“料斗”閥門。
② When adding water to the mixing drum and flushing the hopper tank and discharge tank, first open the valve at the bottom of the water tank, and then open the "hopper" valve.
③沖洗車身時，先開啟水箱底部閥門，后直接使用車尾沖洗裝置。
③ When washing the body, first open the valve at the bottom of the water tank, and then directly use the rear washing device.
攪拌車預拌混凝土操作及供水的正常操作的相關內容就到此講解完畢了，您對此有什么想咨詢的問題就來我們網站http://www.qirongguanjia.cn看看吧！
This is the end of the explanation of the normal operation of the premixed concrete and water supply of the mixer truck. If you have any questions about this, please come to our website http://www.qirongguanjia.cn Look!
