In general, if strong acid and strong alkali are used to corrode, the car tank may be damaged, and the cost is high, requiring a lot of acid and alkali. Now there is a special cleaning industry, with a cost of about 5000. It needs to be hit with an air cannon. One person should go in and clean up the solidified concrete. Therefore, we should pay attention to the cleaning after use and the shutdown time control during use. The more timely the concrete mixing tank is stopped, the easier it is to clean up the concrete.
另外需要注意的是，遇到這種情況，車損險是不予賠付的。按照車險規定：因自身運載貨物或則車內物體運動碰撞導致本車車損，屬責任免除范圍。根據保險的近因原則，導致罐體損失的直接原因罐體停轉、水泥凝固，而非意外事故導致罐體損失，所以是不予賠付的 。
In addition, it should be noted that in this case, the vehicle damage insurance will not be compensated. According to the provisions of vehicle insurance: the damage of the vehicle caused by the movement and collision of its own goods or objects in the vehicle belongs to the scope of liability exemption. According to the principle of proximate cause of insurance, the direct cause of tank loss is tank shutdown and cement solidification, rather than tank loss caused by accident, so it is not compensated.
也就是說如果遭遇罐體停轉而混凝土凝固所受損失，是無法要求保險公司賠付的。
In other words, if the tank stops and the concrete solidifies, the insurance company cannot be required to compensate.
混凝土攪拌車在作業過程中如果液壓系統發生故障，而剛好附近也沒有可以使用的高壓油管及救急的攪拌車，那么時間一長攪拌筒里的混凝土就會凝固在罐體內，一但混凝土凝固那么罐體基本上就算報廢了。
If the hydraulic system of the concrete mixer fails during operation, and there is no high-pressure oil pipe and emergency mixer nearby, the concrete in the mixing drum will solidify in the tank over time. Once the concrete solidifies, the tank will basically be scrapped.
那么是否沒有一點回旋的余地呢，世事無。當混凝土攪拌車遇上這種特殊情況時，如果不想更換罐體，可以請的清理人員對罐體進行破拆作業，其方法是將罐體用氧焊切割一個可供一個進入的大洞，然后用破拆機械，一點點進行破拆，人員進入罐體內一點點的進行破拆，直到混凝土清理干凈。把罐體切割口用電焊封閉。
So is there no room for maneuver? There is no absolute in the world. When the concrete mixer meets this special situation, if you don't want to replace the tank, you can ask professional cleaning personnel to break and dismantle the tank. The method is to cut a large hole for one access with oxygen welding, then use the breaking and dismantling machinery to break and dismantle it bit by bit, and finally enter the tank to break and dismantle it bit by bit until the concrete is cleaned. Finally, seal the cutting opening of the tank body with electric welding.
Thank you for reading. Source of this article: automatic concrete mixer. For more contents and questions, please click: http://www.qirongguanjia.cn We will continue to work hard to provide you with services. Thank you for your support!
